Dominator Small Engine Remote Start/Stop Kit – Honda GX160/GX200 Install Guide

Install the Dominator Small Engine Remote Start/Stop Kit on a Honda GX160 or GX200 (electric start). Direct-connect loom — no separate end harness. Shop the Small Engine kit · Need the Large Engine kit (GX390/GX630/GX690)? →

WILL NOT WORK WITH HONDA iGX800
Notice: Multi-harness versions of this remote kit have been discontinued as of November 2026.
WarningIf you have no electrical experience, do not install this remote — see a professional. Do not open the control box for any reason unless we instruct you to. Opening it voids the warranty.
Engines coveredHonda GX160 and GX200 with electric start. Also works with Honda CRX engines — wiring colors are the same. Not for GX390 / GX630 / GX690 — use the Large Engine kit. Not for iGX700 / iGX800.
Small Engine Remote Start/Stop kit layout

What’s in the box: waterproof receiver, ~10 ft corrugated loom, orange A/B/C/D fob, and direct-connect wire ends.

Boxed Small Engine Remote Start/Stop Kit

Ships boxed. Packers: use box size 12×9×6.

1. Remote buttons

Orange remote fob upright A/B top C/D below

Orange industrial fob — upright, A/B on top, C/D below.

Button Function
C Engine Start (momentary — hold until it starts)
D Engine Stop
A / B Unused on this start/stop kit

2. Safety

  • Do not open the control box for any reason unless we instruct you to.
  • Disconnect the battery before installation.
  • Verify every connection before reconnecting power.
  • Keep the loom away from exhaust and sharp edges.
  • Do not pressure-wash or submerge the receiver.

3. Mount the receiver

  • Mount upright, protected from direct spray and heat.

4. Direct-connect wiring (GX160 / GX200 / CRX)

There is no separate wiring harness adapter on the end of the loom. Connect the color-coded leads straight to the engine. Honda CRX engines use the same wire colors.

Direct-connect wire ends

Wire ends: red + black ring terminals; yellow and green each split for in-line install.

Honda GX engine solenoid and harness connection points

Where it connects on the engine: starter solenoid / kill / start points on a Honda GX (from the P40 Dominator Remote Flush Guide — photo-engine-wiring-gx-example).

Wire Where it goes
RED (ring) Battery positive (+) or the positive side of the starter solenoid.
BLACK (ring) Engine block ground (solenoid mounting screw / starter bolt).
YELLOW (split pair) Kill / stop. Disconnect the engine yellow bullet; plug remote yellow in-line.
GREEN (split pair) Start. Disconnect black/white at the starter solenoid; connect green in-line on each side.

Quick reference: Red = power · Black = ground · Green = start · Yellow = stop/kill.

5. Power-up check

Reconnect the battery. Voltmeter at the receiver ≈ 12.0V.

6. Operation

  • Hold C to start.
  • Press D to stop.

7. Pairing

Remotes ship pre-paired. Do not re-pair unless support tells you to.

8. Warranty

30-day warranty. Incorrect wiring or opening the control box without instruction voids the warranty.

Support: Info@CigarCitySoftwash.com · 813-686-7638